Castle Dungeon Gothic 3D Backgrounds Set of 3 (城の地下牢ゴシック3D背景 3種セット) 城の地下牢ゴシック3D背景 3種セット

Content ID：2320159

- Report to administrator

50 CLIPPY

たら238

This material collection includes materials that can be used in Studio Mode. (What is Studio Mode?)

Translated by

This is a background material made entirely of the dungeons of the castle in 3D. The stone corridor is lined with iron-barred prisons on either side, with an iron band door and guard's desk at the back, and an ascending staircase at the opposite end. Inside the prison, there are different bunks, piles of straw, chains and skeins on the walls.
It can be used for prisoner scenes, prison escapes, rescues, visits, etc.

There are three types of sets:
・Castle dungeon (whole): 21.6m long and 3.4m wide corridor. 12 prisons (2 of which have open doors), stairs, guard desks
・ Castle dungeon (1 section, for connecting): The corridor and the left and right prisons are cut in circles. You can make it any length you want by arranging them in X 360 cm increments.
・Castle prison (one room): One prison and a corridor. For the closer picture

It is shaped so that it is difficult to break by line extraction (LT conversion). Since it is made in actual size (cm), it can be used side by side with 3D drawing figure. It comes with a camera angle.
"Castle Underground Waterway" is a sister material of the same construction. お城の地下牢を、まるごと3Dで作った背景素材です。石の廊下の両側に鉄格子の牢が並び、奥には鉄の帯の扉と見張りの机、反対の端には上り階段があります。牢の中は寝台やわらの山、壁の鎖と手かせなどが部屋ごとに違います。
囚われの場面、脱獄、救出、面会などに使えます。

次の3種類のセットです。
・城の地下牢（全体）：長さ21.6m・廊下の幅3.4m。牢12部屋（うち2つは扉が開いています）、上り階段、見張りの机
・城の地下牢（1区画・つなげる用）：廊下と左右の牢の輪切り。Xに360cmずつ並べると好きな長さにできます
・城の牢屋（ひと部屋）：牢ひとつと廊下の部分。寄りの絵に

線抽出（LT変換）で途切れにくいように形を整えてあります。実寸（cm）で作ってあるので、3Dデッサン人形と並べてそのまま使えます。カメラアングル付きです。
「城の地下水路」とは同じ作りの姉妹素材です。

■ Contents of the set (3 3D materials)

The castle's dungeons (entirety...... Length 21.6m. 12 prisons (2 open doors) on each side, an ascending staircase, a watchman's desk and an iron band door, a hanging iron cage, a wall chain, torches, a floor ditch and an iron drain

・ The dungeon of the castle (1 section, for connecting) ...... Length 3.6m. Corridors and left and right prisons

・Castle prison (one room) ...... One prison and a corridor

■ How to connect

・ 1 section: Arrange X by 360 cm (7 sections are lined up to make sure that no seams appear)

■ Size (actual size)

・Corridor: 21.6m long and 3.4m wide. Pillar spacing 3.6m. Ceiling starting point 3.0m, summit approx. 5.0m

・Prison: 3.0m wide and 3.4m deep. The top of the ceiling is about 3.3m. A small window with iron bars high in the back wall

・Opening of the prison: 2.1m wide and 2.55m high. Lattice door: width 90cm, height 2.0m

・Lookout desk: Width 1.3m, Depth 75cm, Height 76cm

・Stairs: 2.2m wide, 14 steps (1 step 18cm) climb 2.52m

・The origin is in the middle of the floor.

■ Camera Angle

・Overall: Panoramic view of the corridor / Stairs from the back / From inside the prison / Small window in the back / Lattice / Open door / Guard's desk / Looking up / Looking up at the stairs / Low line of sight

・ 1 section: Diagonally / Straight to the back / From inside the prison

・Prison: Lattice / Inside the prison / Small window in the back

■ Where I built it

・Iron grate: A round bar was cut according to the arch of the opening and inserted into the stone. The horizontal band is flush with the door crosswood.

・Lattice doors: frames, lattices, lock boxes, hinges. The doors of the entire 2 rooms are open

・Inside the prison: wooden bed, straw rug and blanket, stone stool, straw pile, tub, round chair, wall chain and hand shackles (4 combinations)

・Lookout place: desk, lamp, cup, round chair, key bundle on the wall, iron band door

Suspended iron cages, floor grooves and square iron drains

・All textures are original. No characters are used

■ About line art (LT conversion)

・ Steps and chamfers are made according to the line extraction to prevent dotted lines and interruptions.

・ The example of the line drawing shown is made in Blender. The way the line comes out is slightly different from the LT conversion of the CLIP STUDIO.

・ If you make the canvas large (width 4000px or more) and extract the lines thinly, it will come out beautifully.

■ Approximate number of polygons

・Overall: Approx. 65,000 triangles / 1 section: Approx. 13,000 triangles / Prison: Approx. 07,000 triangles

■ Please note

・ The introduction image is an image drawn with Blender. CLIP STUDIO's 3D display changes the direction of light and the way shadows appear.

・ The flame of the torch or lamp does not glow (it is a colored shape)

・Since it is a background seen from the inside, the outside of the building is not made. There is nothing beyond the cut of one compartment and the prison (hide side by side)