Castle Underground Waterway Gothic 3D Background Set of 4 (城の地下水路ゴシック3D背景 4種セット) 城の地下水路ゴシック3D背景 4種セット

Content ID：2320157

- Report to administrator

50 CLIPPY

たら238

This material collection includes materials that can be used in Studio Mode. (What is Studio Mode?)

Translated by

This is a background material made entirely in 3D of the waterway that flows under the castle. A stone ceiling with pointed arches continues to the depths, with a dark channel in the middle and stone passages on both sides. There is a cross ceiling and a stone bridge at the fork, an iron sluice gate at the back, and a waterfall falling down stone steps at the opposite end.
It can be used for infiltration, escape, pursuit, and escape to hideouts.

There are four types of sets:
・Underground waterway of the castle (overall): Total length 30.6m, width 5.4m, ceiling height approx. 6.3m
・ Underground waterway of the castle (1 section, for connection): 3.6 m long ring. You can make it any length you want by arranging them in X 360 cm increments.
・ Underground waterway of the castle (1 section, side hole of iron bar): Side hole of iron bar on one side of the same section
・ Underground aqueduct of the castle (branch of the stone bridge): stone bridge and cross ceiling, side hall and stairs

It is shaped so that it is difficult to break by line extraction (LT conversion). Since it is made in actual size (cm), it can be used side by side with 3D drawing figure. It comes with a camera angle.
"Castle Dungeon" is a sister material of the same construction. お城の地下を流れる水路を、まるごと3Dで作った背景素材です。とがったアーチの石の天井が奥まで続き、真ん中に暗い水路、両側に石の通路があります。分岐には十字の天井と石橋、奥には鉄の水門、反対の端には石の段を落ちる滝があります。
潜入や脱出、追跡、隠れ家への抜け道などの場面に使えます。

次の4種類のセットです。
・城の地下水路（全体）：全長30.6m・幅5.4m・天井の高さ約6.3m
・城の地下水路（1区画・つなげる用）：長さ3.6mの輪切り。Xに360cmずつ並べると好きな長さにできます
・城の地下水路（1区画・鉄格子の横穴）：同じ1区画の片側に鉄格子の横穴
・城の地下水路（石橋の分岐）：石橋と十字の天井、横の広間と上り階段

線抽出（LT変換）で途切れにくいように形を整えてあります。実寸（cm）で作ってあるので、3Dデッサン人形と並べてそのまま使えます。カメラアングル付きです。
「城の地下牢」とは同じ作りの姉妹素材です。

■ Contents of the set (4 3D materials)

・The underground waterway of the castle (entirely)...... The total length is 30.6m. Waterway and passage on both sides, cross ceiling branch and stone bridge, side hall and ascending stairs, back sluice gate and hoist, waterfall on the step at opposite end, side hole of iron bar, drainage, iron ladder, small boat, barrel, wooden box, torch

・ Underground waterway of the castle (1 section, for connection) ...... Length 3.6m. Pillar, 2 torches and 2 drains

・ The underground channel of the castle (1 section, side hole of iron bar) ...... Length 3.6m. Side holes in the wall on one side of the iron bar

・ The underground waterway of the castle (branch of the stone bridge) ...... Length 12.6m. Branches and stone bridges, side halls, stairs up

■ How to connect

・ 1 section: Arrange X by 360 cm (7 sections are lined up to make sure that no seams appear)

・ When continuing one section in a branch: Place it X±810 cm from the origin of the branch, and arrange it 360 cm from there.

■ Size (actual size)

・Tunnel: 5.4m wide (2.7m waterway + 1.35m passage). Pillar spacing 3.6m. Ceiling starting point 2.5m, summit approx. 6.3m

・The water surface is 85 cm below the surface of the passage. The face of the passage is 0 height.

・Stone bridge: Width approx. 1.8m, handrail height 80cm

・Side hole: Width 1.5m, height 2.05m. Sluice gate and waterfall opening: width 2.4m, height 3.2m

・Stairs: 2.2m wide, 14 steps (1 step 18cm) climb 2.52m

■ Camera Angle

・Overall: Panoramic view from the passage / Line of sight of the water surface / Sluice gate from the bridge / View of the stone bridge / Stone bridge from the hall / Ascending stairs / Waterfall of steps / Side hole of iron bar / Sluice gate / Looking up

・ 1 section and side hole: oblique / straight / looking at the surface of the water

・ Branch: Stone bridge / From the hall / On the bridge / Up stairs / Looking up

■ Where I built it

・Ceiling: A cylindrical ceiling with stone steps lined up along the arch. Branching is a cross ceiling with diagonal ribs and keystones

Drainage grooves on the walls of the channel: stone frame of arch and iron lattice, receiving stone

・Terraced waterfall: Water falls down three stone steps that fill the width of the channel, and white bubbles underneath

・Sluice gates: pointed iron lattices, hoists, pulleys, chains

・Small boat: There is a stool and a bottom plate, and the tip of the boat is connected to the wall with a chain.

・All textures are original. No characters are used

■ About line art (LT conversion)

・ Steps and chamfers are made according to the line extraction to prevent dotted lines and interruptions.

・ The example of the line drawing shown is made in Blender. The way the line comes out is slightly different from the LT conversion of the CLIP STUDIO.

・ If you make the canvas large (width 4000px or more) and extract the lines thinly, it will come out beautifully.

■ Approximate number of polygons

・Overall: Approx. 31,000 triangles / Branch: Approx. 17,000 triangles / 1 section: Approx. 2,300 triangles / Side hole: Approx. 2,700 triangles

■ Please note

・ The introduction image is an image drawn with Blender. CLIP STUDIO's 3D display changes the direction of light and the way shadows appear.

・The flame of the torch does not glow (it is a colored shape). Water does not move (it is a colored surface)

・Since it is a background seen from the inside, the outside of the building is not made. 1 There is nothing beyond the cut of the compartment and branch (hide side by side)