It is a household trampoline with a protective net. It has a diameter of 1,400 mm and a jumping surface height of 320 mm. From the thick edge pads, the net rises 820 mm with 6 posts. The net has a fine density of 64 vertical and 18 wide. In front is an inverted U-shaped doorway that opens and closes with a zipper. It also has left and right bands and pullers. Handrails and hanging rings above the net. With black grip and 2 hanging rings. The legs are U-shaped in three pairs. The grounding part is a buffer pad with a diameter of 150 mm. All parts are object separate, so you can also erase only the hanging ring. The origin is the center of the contact plane, and the doorway and front are in the -Y direction. Comes in 4 angles. 保護ネット付きの家庭用トランポリンです。直径1,400mm、跳ぶ面の高さは320mm。分厚い縁パッドから、6本の支柱でネットが820mm立ち上がります。ネットは縦64本と横18本の細かい密度にしました。正面にはファスナーで開閉する逆U字の出入口。左右の帯と引き手も付いています。手すりと吊り輪はネットより上。黒いグリップと吊り輪2つ付き。脚はコの字型が3組。接地部は直径150mmの緩衝パッドです。部品はすべて別オブジェクトなので、吊り輪だけ消すこともできます。原点は接地面の中心、出入口と正面は−Y方向。4アングル入り。
About this material
It is a household trampoline with a diameter of 1,400 mm and a net. Railings and hanging rings pass over the net.

Net
Height 820 mm, 6 supports. The mesh is made with a fineness of 64 long + 18 wide. The other side can be seen through, and if you make a line drawing, the net will become a line as it is.
There is one inverted U-shaped entrance in front (about 680 mm wide × 520 mm high). It has a fastener strip and a puller.
Handrails and hanging rings
Above the net, the bar passes through the center of the circle. It is a position where the person jumping in the middle can reach out as it is. Width 1,358 mm, with black grip. Two hanging rings with a diameter of 165 mm are placed closer to the center, lowering 190 mm from the bar. The hanging ring is a separate object, so it can be erased.
Legs and pads
Three sets of U-shaped legs (6 points of grounding). The grounding part is a buffer pad with a diameter of 150 mm. The edge pad has an outer diameter of 1,400 mm × an inner diameter of 1,040 mm.
4 angles
Four items are registered: front, back, right, and left.
LT Conversion
Below is the main line converted to LT with the actual CLIP STUDIO machine.

Specifications
- Diameter 1,400 mm / Jumping surface height 320 mm / Net top edge 1,215 mm / Handrail 1,555 mm
- Edge pad Outer diameter 1,400 × Inner diameter 1,040mm / Jumping surface Diameter 1,070mm
- Protective net: height 820mm, 6 pillars, mesh 64 long + 18 horizontal
- Entrance/exit: 1 place at the front, inverted U-shaped (width approx. 680 ×, height 520 mm), with zipper band and puller
- Handrail: passes through the center of the circle / width 1,358 mm, with black grip
- Hanging rings 165mm diameter, 190mm below the bar (two near the center, another object)
- Legs: U-shaped 3 pairs (6 grounding points), shock absorber 150mm diameter
- 4 angles (front, back, right, left)
- Origin: center/doorway and front of the ground plane: −Y direction
この素材について
直径1,400mm、ネット付きの家庭用トランポリンです。ネットの上に手すりと吊り輪が渡ります。

ネット
高さ820mm、支柱6本。網目は縦64本+横18本の細かさで作ってあります。向こう側が透けますし、線画にすると網がそのまま線になります。
正面には逆U字の出入口が1か所(幅約680×高さ520mm)。ファスナーの帯と引き手が付きます。
手すりと吊り輪
ネットより上、円の中心を通る位置にバーが渡ります。真ん中で跳んでいる人物がそのまま手を伸ばせる位置です。幅1,358mm、黒いグリップ付き。中心寄りに直径165mmの吊り輪が2つ、バーから190mm下がります。吊り輪は別オブジェクトなので消せます。
脚とパッド
コの字型の脚が3組(接地6点)。接地部は直径150mmの緩衝パッドです。縁パッドは外径1,400×内径1,040mm。
アングル4件入り
正面・背面・右・左の4件を登録してあります。
LT変換
下はクリスタの実機でLT変換した主線です。

仕様
- 直径1,400mm/跳ぶ面の高さ320mm/ネット上端1,215mm/手すり1,555mm
- 縁パッド 外径1,400 × 内径1,040mm/跳ぶ面 直径1,070mm
- 保護ネット 高さ820mm・支柱6本・網目は縦64本+横18本
- 出入口:正面に1か所・逆U字(幅約680 × 高さ520mm)・ファスナー帯と引き手付き
- 手すり:円の中心を通る/幅1,358mm・黒いグリップ付き
- 吊り輪 直径165mm・バーから190mm下(中心寄りに2つ・別オブジェクト)
- 脚:コの字型3組(接地6点)・緩衝パッド 直径150mm
- アングル4件(正面・背面・右・左)
- 原点:接地面の中心/出入口と正面:−Y方向
Material マテリアル
-
default material 初期マテリアル
Configuration 配置
-
default layout 初期レイアウト
Angle アングル
-
Front 正面
-
The backside 背面
-
Right 右
-
Left 左
Update history
2026/10/4 Material review (improvement of accuracy, addition of materials, clarification of contour lines), registration of angles
2026/10/4 素材見直し(正確性向上、マテリアル追加、輪郭線の明確化)、アングルの登録
Old version