
Since the line drawing is drawn directly on the texture, it is a 3D model that does not require LT conversion or other software (the image shown has no addition).
This automatic door was made so that both doors work together.
Instructions for use.
It requires a bit of configuration.
In the material collection, the automatic door (movable) and the door edge are included as separate object.
Drag and drop the door edge directly onto campus first (basically, there is no one first).
Next, drag and drop the automatic door (movable) into the layer that contains the edge of the door on the canvas.
Then the two object are placed nicely.
To open and close the door, use the movable slider on the automatic door.
Both doors start to move at the same time (* If it is manual, the doors will not move at the same time. If so, please reset it in the layout).
Also, if the movable slider does not appear when moving, the object on the edge of the door is selected.
Make sure and select the automatic door (movable).

テクスチャに線画を直接描いているのでLT変換や他のソフトも必要のない3Dモデルです(載せている画像は加筆ゼロです)。
今回の自動ドアは、両方のドアが連動するように作りました。
使い方説明。
ちょっと設定が必要です。
素材集の中に、自動ドア(可動)とドアのフチが別々のオブジェクトとして入っています。
最初にドアのフチをキャンパスに直接ドラック&ドロップしてください(基本どちらが先とかありません)。
次に自動ドア(可動)を、いまキャンバスにあるドアのフチが入っているレイヤーの中にドラック&ドロップしてください。
すると二つのオブジェクトがいい感じに配置されます。
ドアの開閉は、自動ドアの可動スライダーを使って動かしてください。
両扉が同時に動きだします(※手動だとドアは同時に動きません。もしものさいはレイアウトでリセットしてください)。
あと、可動時のさい可動スライダーが出ない場合は、ドアのフチのオブジェクが選択されてます。
確かめて、自動ドア(可動)を選択してください。