Indoor playground equipment for toddlers (slides, swings, jungle gym) (幼児用の屋内遊具（滑り台・ブランコ・ジャングルジム）) 幼児用の屋内遊具（滑り台・ブランコ・ジャングルジム）

Content ID：2298607

- Report to administrator

Free

Didymoi.A

This material can be used in Studio Mode. (What is Studio Mode?)

Translated by

Made of white resin pipes and mint fittings, this is an indoor playground equipment for young children. A 3-in-1 configuration with a swing on the left and a jungle gym and slide on the right. The jungle gym is a three-tier lattice. The deck is on the right, and the top is open. At the back of the deck is a 45-degree staircase built with the same pipe as the frame, and in the foreground is a slide. It is a straight flow line that goes up and slides down as it is. The slide is oriented in the same direction as the swing, so even if two people play, they will not collide. The horizontal mounting material of the swing was adjusted to a height of 675 mm in the middle of the third tier. The seat is bucket-shaped with a backrest and a front bar. There are two holes in the front for passing the legs, and they are divided into left and right by a crotch partition, making it easy to put on for infants. Each hanging tool has one object, and the origin is on the horizontal mounting material. If you turn it around the X axis, you will get a natural pendulum with the suspension point as the fulcrum. 白い樹脂パイプとミントの継手でできた、幼児用の室内遊具です。左にブランコ、右へジャングルジムと滑り台が並ぶ3in1の構成。ジャングルジムは3段の格子。右にはデッキが載り、その上は開けてあります。デッキの奥には枠と同じパイプで組んだ45度の階段、手前には滑り台。上ってそのまま滑り降りる、一直線の動線になっています。滑り台はブランコと同じ向きなので、2人で遊んでもぶつかりません。ブランコの横架材は3段目の中ほど、675mmの高さに合わせました。座面は背もたれと前バーの付いたバケット型。手前に足を通す穴が2つあり、股の仕切りで左右に分かれた、幼児用の乗せやすい形にしてあります。吊り具ごと1つのオブジェクトで、原点は横架材の上。X軸まわりに回せば、吊り点を支点にした自然な振り子になります。

About this material

Slide, swing, and jungle gym are integrated into this indoor playground equipment for young children.

Four angles are registered: front, back, right, and left.

Select from the tool property angles to switch to that orientation.

How to use the gimmick

The swing — swing_seat has its origin on the horizontal mounting material (hanging point).

Just by turning it around the X-axis, you can swing the lifting tool back and forth. The angle at which you turn it is the runout angle as it is.

Since it is a short hanging for indoor use, it is enough to shake it 20 degrees.

object Hierarchy (FBX version)

Parent / Child / Content

Gym / gym_frame / White pipe frame (three-tier lattice) and mint fittings

gym_deck / Deck and 2 steps on the far right

gym_slide / Slide (sliding surface, edge, leg)

Swing / swing_frame / A-shaped legs, horizontal mounts, cloud-shaped panels, floor binders

swing_seat / Bucket type seat and lifting device (movable)

If you move the parent, the child will follow, but if you choose the child, only the child can be moved.

Best practices

Place it in the living room — with a total height of 800 mm, it doesn't feel oppressive when placed side by side with a sofa or an adult.

Riding – The seat of the swing is 170 mm, the top edge of the deck and slide is 344 mm.

Climb — The section on the far left has a bare three-level lattice, so you can draw the movement of climbing.

Flow line — A straight line that slides up from the stairs at the back, to the deck, and then down to the front.

Tips for LT conversion

White pipes take shape only with contour lines. If you put only the fittings and seat on the tone,

The color coding typical of the product remains even in monochrome.

Specifications

Installation dimensions Approx. 1,850 × 1,300mm / Height 800mm
Jungle gym: 3 tiers (300, 550, 800mm) / 3 lattice on the back left, 1 lattice on the front left
Deck 560 × 480mm, height 344mm (top is open. 550mm handrail only on the right edge)
2 stairs (115/229mm) / 2 45-degree diagonal timbers at the back of the deck with the same pipe as the frame
Slide: Total length 820mm, width 460mm, width 460mm, 344mm→20mm (from right edge to front / same direction as the swing)
Swing horizontal mounting material 675mm (middle of the third tier), seat surface 170mm, seat to horizontal mounting material 460mm
Seat 340 × 260 mm, 2 holes for passing legs (about 100 mm wide), with crotch partition and front bar
Fulcrum: swing_seat is on the horizontal mount (swings when turned around the X axis)
Origin: Center of the ground plane / Front: −Y direction

この素材について

滑り台・ブランコ・ジャングルジムが一体になった、幼児用の室内遊具です。

正面・背面・右・左の4アングルを登録してあります。

ツールプロパティのアングルから選ぶと、その向きに切り替わります。

ギミックの使い方

ブランコ — swing_seat は原点が横架材の上（吊り点）にあります。

X軸まわりに回すだけで、吊り具ごと前後に振れます。回した角度がそのまま振れ角です。

室内向けの短い吊りなので、20度も振れば十分に見えます。

オブジェクトの階層（FBX版）

親／子／内容

Gym ／ gym_frame ／白いパイプの枠（3段の格子）とミントの継手

gym_deck ／デッキと、右端の階段2段