Create a water surface from selection (選択範囲から水面を作成) 選択範囲から水面を作成

Content ID:2031292

  • 5,006
  • 20 GOLD
  • 200 CLIPPY
This material can be used in Studio Mode. (What is Studio Mode?)

It is a auto action that creates a water surface and reflected light from selection. 選択範囲から水面と反射光を作成するオートアクションです。

Just create selection it and then take action.
You will receive one or two confirmation messages along the way, but please press OK in each case.
If the basic expression color is a monochrome document, executing the "monochrome only" action will work faster.
Since the created layer is separated, you can freely change the color, density, etc.
・ Execute with the sub drawing color turned on in white and the main drawing color in black.

・ If the selection is too small, it may not be possible to create it beautifully.
・ The processing is a little heavy, so please save the document in advance before use.
・ Since the created layer group is rotated upside down with the last command
You can reverse the direction of light and dark by undoing once.


2023/9/12
Published
Updated on 2023/9/13
Because the basic expression color did not work properly unless it was a monochrome document
Fixed and added actions to work in color and gray
<使い方>
選択範囲を作成してからアクションを実行するだけです。
途中で確認のメッセージが1回もしくは2回出ますが、いずれもOKを押してください。
基本表現色がモノクロのドキュメントの場合は『モノクロ専用』アクションを実行すると高速に動作します。
作成されたレイヤーは分離しているので色や濃度などを自由に変更できます。
<補足>
・サブ描画色を白、メイン描画色を黒でオンの状態で実行してください。

・選択範囲が小さすぎると綺麗に作成できない場合があります。
・処理が少し重いので、事前にドキュメントを保存してからご使用ください。
・作成したレイヤー群は最後のコマンドで逆さまに回転させているので
 アンドゥを一回行うことで明暗の方向を逆転できます。


2023/9/12
公開
2023/9/13 更新
基本表現色がモノクロのドキュメントでないと正常に動作しなかったため
カラーやグレーでも動作するようにアクションを修正・追加

Old version

Content ID:2031292

Published : 2 years ago

Last updated : 2 years ago

ys_cs's profile Go to profile

使いやすく綺麗な線画の出る3D素材づくりを心掛けています。 ちょっと便利なアクションも公開中。 【お詫びとお礼】 いつもありがとうございます。 ある素材一点の価格設定に手違いがありました。大変申し訳ございませんでした。 ご支援いただいた(と勝手に解釈させていただきます)方には重ねてお礼申し上げます。 2025/3