Expand Campus Temporarily (illustration only) (キャンパスを一時的に拡大(イラスト専用)) キャンパスを一時的に拡大(イラスト専用)

Content ID:1778146

  • 160
  • Free
This material can be used in Studio Mode. (What is Studio Mode?)

It is auto action to enlarge the campus size temporarily to make it easier to draw under. キャンパスサイズを一時的に拡大して、下描きをしやすくするオートアクションです。

Important points

This auto action is not available in a comic book for the purpose of increasing the size of the campus .

How to use

1 Run the campus expansion A.

2 Then, since the guide line that changes the campus size comes out, be sure to set up, the bottom, the left, and the right all to be larger than the original campus size and CLICK The OK of the dialog.
Note: If the size is smaller than the original, the size will change when you return to the original campus size.


3. The "Campus temporary enlargement" layer is created and the thin light blue area is the area where the campus is enlarged.
Do not remove this layer later because it is necessary to return the campus size to its original size.

4. We will draw down on the enlarged campus.

5. Run "Shrink Campus B" to return to the original campus size.


I want to draw the person who is using the example and the piece, but if I can't draw well without the elbow




注意点

このオートアクションは一度キャンパスサイズを大きくするアクションのため、漫画原稿では使用できません。

使用方法

1.「キャンパス拡大A」を実行します。

2.するとキャンパスサイズを変更するガイド線が出てくるので、必ず上・下・左・右全てが元のキャンパスサイズより大きくなるように設定してダイアログのOKをクリックします。
※ここで元のサイズより小さくすると、元のキャンパスサイズに戻すときにサイズが変わってしまうので、ご注意ください。


3. 「キャンパス一時的拡大」レイヤーが作成され、薄い水色の部分がキャンパスを大きくした部分となります。
このレイヤーは後でキャンパスサイズをもとの大きさに戻すために必要なので、消さないでください。

4. 大きくなったキャンパスで下描きなどをしていきます。

5. 「キャンパス縮小B」を実行すれば、もとのキャンパスサイズに戻ります。


使用例・ピースをしてる人物を描きたいが、ひじを描かないとうまく描けない場合




Content ID:1778146

Published : 3 years ago

Last updated : 3 years ago

ヒトツカミ's profile Go to profile

漫画やイラストに使いやすい素材を作っていきたいです。 boothでも素材の販売を開始しました。https://hitotsukamisozai.booth.pm/