It is a perforated board 3D that can be adjusted in size.
サイズ調整ができる有孔ボード3Dです。
Example: When creating a 9-hole × 9-hole perforated board
(1) Prepare a set of 4 perforated boards (5×5).
(2) Of the four boards, set the position of the "Y axis" of the "1" and "2" boards to "-2.5".

(3) Next, set the position of the "X axis" of the "2" and "3" boards to "-2.5".

Now the holes overlap to form a perforated board with a 9-hole × 9-hole appearance.
Set the position to "-5" to reduce 2 holes, "-7.5" to reduce 3 holes, and "-10" to reduce 4 holes.
When moving the perforated board, move all four boards together.
Duplicate if you need a number. (If you want to duplicate it, reset rotate it, duplicate it, and move it in multiples of 2.5 from the original position to make it stick snugly)
There are three original sizes. All can be adjusted in the same way.
・ (5×5) Set of 4 * The one used in the above example
・(10×10) Set of 4
・(15×15) Set of 4
The weight has been reduced so that the hole does not collapse, but please note that the large size is also large in the data.
In addition, we also distribute perforated boards with small items and tabletop perforated boards. Please feel free to use it.
作成例 9穴×9穴の有孔ボードを作成する場合
① 「有孔ボード(5×5)4枚セットを用意します。
② 4枚に分かれているボードのうち、「1」と「2」のボードの「Y軸」の位置を「-2.5」にします。

③次に、「2」と「3」のボードの「X軸」の位置を「-2.5」にします。

これで穴が重なって、9穴×9穴の外観の有孔ボードになります。
位置を「-5」にすると2穴、「-7.5」にすると3穴、「-10」にすると4穴減らせます。
有孔ボードごと移動させる際は、4枚まとめて動かしてください。
数が必要な場合は複製してください。(複製する場合は、回転をリセットしてから複製し、元位置から2.5の倍数で動かすとぴったりくっつけられると思います)
元サイズは3種類です。すべて同じ方法で調整できます。
・(5×5) 4枚セット ※上記例で使用したもの
・(10×10) 4枚セット
・(15×15) 4枚セット
穴がつぶれない程度に軽量化しておりますが、大きいサイズはデータも大きいのでご注意ください。
そのほか小物つき突っ張り有孔ボードや卓上有孔ボードなども配布しています。ご自由にお使いください。
Size-adjustable perforated board サイズ調整できる有孔ボード