[Balloon] mellow tail + easy distortion ([フキダシ]まろやかしっぽ+簡単歪ませ) [フキダシ]まろやかしっぽ+簡単歪ませ
Content ID:2045019
-
13,554
The default tail tool is too crispy and does not fit the pattern.



I made it possible to grow a mellow tail.
・ The tail grows by directly distorting the vector.
・There will be no inadvertent separation.
・ If you want to erase it later, you can restore it by erasing only the control point of the tail part.

Bonus
It is a tool that roughly distorts balloons.
This may be easier than the one attached to the balloon to do ...

* It is recommended to grow the tail at the very end. If you distort it after attaching the tail, it may crumble.
Balloon to do
https://assets.clip-studio.com/ja-jp/detail?id=2042558
───────────
2025/06/16
Added a tail tool that can be used on raster layer.
It is based on the Liquify tool. Stretch the tail in the direction you want it to grow from the top of the balloon line.

※Precautions
・ The shape of the tail changes slightly when tracing directly above the line or from the inside or outside of the balloon.
・ On layers with a gray color mode, it may bleed a little like the tail at the bottom.
・ The line becomes thinner as it is stretched, so if the balloon wire is originally thin, it may be less than 1px.
デフォルトのしっぽツールがシャキッとしすぎていて絵柄に合わないので



まろやかなしっぽを生やせるようにしました。
・ベクターを直接歪ませることでしっぽを生やしています。
・うっかり分離することはありません。
・後から消す場合はしっぽ部分の制御点だけ消せば元通りです。

オマケ
フキダシをざっくり歪ませるツールです
するするフキダシにつけたものよりこっちの方が簡単かも…。

※しっぽは一番最後に生やすことをお勧めします。しっぽをつけたあとに歪ませると崩れることがあるので。
するするフキダシ
https://assets.clip-studio.com/ja-jp/detail?id=2042558
───────────
2025/06/16
ラスターレイヤーでも使えるしっぽツールを追加しました。
ゆがみツールがベースです。フキダシ線の上からしっぽを伸ばしたい方向に引き延ばします。

※注意点
・線の真上をなぞるか、フキダシの内側または外側からなぞるのとでしっぽの形がちょっと変わります。
・カラーモードがグレーのレイヤーでは、一番下のしっぽのように少し滲む場合があります。
・引きのばす分、線が細くなるので、もともとフキダシ線が細いと1px以下になってしまう場合があります。
Tool ツール