Water mark Set (ウォーターマークセット) ウォーターマークセット

Content ID:2006079

  • 1,855
  • Free





It is a set of six types of water mark pattern.
[Layer property] → [layer color] is colored. Please change it from this item to favorite color.

Note points
When you change the size of a ① material, be sure to check the how to correct tool property the object tool. If it is [bi cubic method] or [high precision], deterioration is reduced even if it transforms to some extent.
The rotation angle of the ② object tool property is [-45] by default. After changing the angle of the material, enter [-45] if you want to revert to the original.

※ The character used is the one that was Ivata Antic STD B based on


This set contains six different watermark patterns.

They are colored by [Layer Properties]-> [Layer Color]. You can change the color from this item to any color you like.

Notes.

(1) When Changing the size of the material, be sure to check the [Interpolation Method] in the tool properties of the object tool. If it is set to [Bicubic Method] or [High Precision], there will be a little deterioration even if the material is deformed to some extent.

(2) The [Rotation Angle] in the object tool properties is set to [-45] By default. If you want to change the angle of the material and then return it to the original angle, enter [-45].





ウォーターマークのパターンが6種類入ったセットです。
[レイヤープロパティ]→[レイヤーカラー]で色をつけています。この項目から好きな色に変更してください。

▼注意点
①素材のサイズを変更するとき、オブジェクトツールのツールプロパティにある[補間方法]を必ず確認してください。[バイキュービック法]か[高精度]になっていれば、ある程度変形しても劣化が少なく済みます。
②オブジェクトツールプロパティの[回転角]はデフォルトで[-45]になっています。素材の角度を変えたあと、元に戻したい場合は[-45]と入力してください。

※使用している文字はイワタアンチックStd Bをベースに加筆したものです


This set contains six different watermark patterns.

They are colored by [Layer Properties] -> [Layer Color] . You can change the color from this item to any color you like.

▼ Notes.

(1) When changing the size of the material, be sure to check the [Interpolation Method] in the tool properties of the object tool. If it is set to [Bicubic Method] or [High Precision], there will be little deterioration even if the material is deformed to some extent.

(2) The [Rotation Angle] in the object tool properties is set to [-45] by default. If you want to change the angle of the material and then return it to the original angle, enter [-45].

Category 1 カテゴリ1

Content ID:2006079

Published : 1 year ago

Last updated : 1 year ago

佐太郎ス's profile Go to profile

インターネットお絵描きマンです。投げCPありがとうございます。ありがたく使わせていただいております。