It is a set of the dragon tail of 3D. 3Dのドラゴンの尻尾セットです。
There are no models of dragons or people in five different sets of dragon tails.
The color has become wacky to make it easier to extract line, and shadows, shading, and contour lines are turned off by default as shown above.
For the Atari of the ① was made as an adjunct to the tail of the original design.

There are seven tails of the joint, and it collapses if it twists it too much although it is possible to operate vertical, lateral, and torsion.
The shape is easy to become beautiful when the angle is adjusted gradually Kara Foundation and ahead.

When you extract line, the center line of the tail other than for the Atari disappears, but I can use it as a line drawing as it is as shown in the bottom right picture if it goes well because the boundary line of the bellows and the projection remain.
The above figure shows extract line result of no adjustment.
Of course, you can use your favorite as a draft without extract line the original model.
I want the impression and this material! Such opinions are being recruited by DM. Thank you so I will be helpful!
3Dのドラゴンの尻尾5種類セットでドラゴンや人のモデルは入ってません。
ライン抽出しやすくするため色が奇抜になっており、上の図のようにデフォルトで影・陰影・輪郭線がオフになっています。
①のアタリ用はオリジナルデザインの尻尾の補助用として作りました。

尻尾の関節は7つ程あり、縦・横・ねじりの動作が可能ですがねじりすぎると潰れます。
根本や先っぽから少しずつ角度を調整すると、形が綺麗になりやすいです。

ライン抽出するとアタリ用以外の尻尾の中心線は消えますが、蛇腹や突起の境界線が残るので上手くいけば右下の図のようにそのまま線画として使えます。
上の図は無調整のライン抽出結果です。
もちろん元のモデルをライン抽出しないで下書き用にするなどお好みで使い分けることもできます。
感想やこんな素材が欲しい!などの意見をDMにて募集しています。参考にさせて頂くのでよろしくお願いします!
3D Object 3Dオブジェクト