Ring 3D__C4 (3D_輪っか_C4) 3D_輪っか_C4

Content ID:2058508

  • 552
This material can be used in Studio Mode. (What is Studio Mode?)

It is a ring that fills the inside while leaving the wires of the wireframe skeleton (3D_ ring _C3) based on the 3D ring.
3DLT conversion.
It is quite large because it is about 3m in diameter.
3Dの輪っかをベースにしたワイヤーフレーム骨格(3D_輪っか_C3)のワイヤーを残しつつ内側を埋めた円環です。
3DLT変換できます。
直径3m程度なので結構大きいです。


It is a ring that fills the inside while leaving the wires of the wireframe skeleton (3D_ ring _C3) based on the 3D ring.
3DLT conversion.
It is quite large because it is about 3m in diameter.
It may also be used for sci-fi gimmicks.
It shows the framework of the third one (3D_ ring _C1).
The mesh of the skeleton is coarse.
The size of the inner diameter is different from the first and second ones.
The roughness of the mesh is different from the fourth one (_C2 3D_ rings).

The size is "The diameter is about 3 meters, and the inner diameter is about 1 meter".




↓ LT converted.











3Dの輪っかをベースにしたワイヤーフレーム骨格(3D_輪っか_C3)のワイヤーを残しつつ内側を埋めた円環です。
3DLT変換できます。
直径3m程度なので結構大きいです。
SF的なギミックにも使えるかもしれません。
三つ目のもの(3D_輪っか_C1)の骨組みを示したものです。
骨組みの網は粗めです。
一つ目、二つ目とは内径のサイズが違います。
四つ目のもの(3D_輪っか_C2)とは網目の粗さが異なります。

サイズ感は 「直径はおおむね3メートル、内径はおおむね1メートル」 です。




↓ LT変換したもの。










Material マテリアル

  • default material 初期マテリアル

Place 配置

  • default layout 初期レイアウト

Content ID:2058508

Published : 1 year ago

Last updated : 1 year ago

RollingRoadRunnners's profile Go to profile