Bathroom dressing room Toilet set (浴室脱衣所トイレセット) 浴室脱衣所トイレセット

Content ID:1836243

  • 59
  • 3,500 CLIPPY
This material can be used in Studio Mode. (What is Studio Mode?)

Bathroom, dressing room, it is a set of toilet.

The color of some of the walls of the bathroom was improved to the point that three lights and a lotion drainage pipe were the cactus.


[Precautions]

The number of vertices is 90,510. Please note the machine specifications.

The material setting is made to the extent that it can be distinguished at the time of the work.

Please set the light source below.

 

See LT conversion for more information.



【 Front 】 * LT Example


【 Overlook 】 * LT Example



[Contents] are as follows.



[Red Frame] switch of open and close state of rubber stopper of bathtub

[Blue frame] bathroom shower layout change

[Green frame] You can arrange the shelves freely by manually changing the height of 1 to 4 shelves.



※ Please remove the check of the light source setting first and use it.




[Movable setting] is as follows.
It may be up and down with the version, but we check the operation each time.

The red frame part is troublesome, but please adjust it to the same number.

(Set to match in 50100, 0)

The lid of the washing machine is not set up because it does not assume the opening and closing.


[Layout Setting]

The bathroom is not recommended for use only then there is only first choice.

I think that it is better to do manually from the object list.



LT is a set example (please be aware of the following LT images only because you are not very familiar)


Example of LT








浴室、脱衣所、トイレのセットです。

照明3か所、化粧台排水管がカクカクだった点、浴室の壁の一部の色を改善しました。


【注意事項】

 頂点数は90,510です。マシンスペックにご留意ください。

 マテリアル設定は作業時に見分けられる程度にしています。

 後述の光源設定をお願いします。

 

 見た目についてはLT変換例をご参照ください。



【正面】※LT例


【俯瞰】※LT例



【内容物】は以下のとおりです。



 【赤枠】浴槽のゴム栓のオープン、クローズ状態の切替

 【青枠】浴室のシャワーレイアウト切替

 【緑枠】手動で棚1~4の高さを変えることで棚板を自由に配置できます



※最初に光源設定のチェックを外してご使用ください。




【可動設定】は以下のとおりです。
バージョンアップに伴い上下することがありますが、都度動作確認をしております。

赤枠部分はお手数ですが同じ数値になるよう調整してください。

(一応0,50,100で一致するよう設定してあります)

なお洗濯機のふたについては開閉を想定していないため設定しておりません。


【レイアウト設定】

浴室のみしてありますが最初に選択する以外は使用をお勧めしません。

オブジェクトリストから手動でしたほうがいいと思います。



LT設定例です(あまり詳しくないので以下のLT画像の設定とだけご承知おきください)


LT化例








Material マテリアル

  • default material 初期マテリアル

disposition 配置

  • Shower hose (NO) bathtub rubber stopper (open) シャワーホース(無)浴槽ゴム栓(開)
  • Shower hose (high) bathtub rubber stopper (open) シャワーホース(高)浴槽ゴム栓(開)
  • Shower hose (NO) bathtub rubber stopper (closed) シャワーホース(無)浴槽ゴム栓(閉)
  • Shower hose (high) bathtub rubber stopper (closed) シャワーホース(高)浴槽ゴム栓(閉)
  • Shower hose (low) bathtub rubber stopper (open) シャワーホース(低)浴槽ゴム栓(開)
  • Shower hose (low) bathtub rubber stopper (closed) シャワーホース(低)浴槽ゴム栓(閉)
  • Toilet cover (closed) トイレ蓋(閉)
  • Toilet cover (closed) トイレ蓋(開)便座(閉)
  • Toilet cover Open Toilet seat トイレ蓋(開)便座(開)

pose parts 可動パーツ

  • Bath water Faucet (Wed) 浴室給水栓(水)
  • Bath faucet (hot water) 浴室給水栓(湯)
  • Bathroom shower switch lever 浴室シャワー切替レバー
  • Bathroom water pipe 浴室給水管
  • Bathroom folding (left) * Move with right and set 浴室折り戸(左)※右とセットで動かす
  • Bathroom folding (right) * Move with left and set 浴室折り戸(右)※左とセットで動かす
  • Bathroom switch (top) lighting 浴室スイッチ(上)照明
  • Bathroom switch (bottom) ventilator 浴室スイッチ(下)換気扇
  • Vanity door (left) 化粧台ドア(左)
  • Vanity door (right) 化粧台ドア(右)
  • Washing water faucet levers 洗濯用給水栓レバー
  • Dressing room Door 脱衣所ドア
  • Toilet cover 便器蓋
  • Toilet 便座
  • Toilet lever 便器レバー
  • Toilet switch (top) lighting トイレスイッチ(上)照明
  • Toilet switch (bottom) ventilator トイレスイッチ(下)換気扇
  • Toilet door トイレドア
  • Toilet door Knob トイレドアノブ

Update history

The color of some of the walls of the bathroom was improved to the point that three lights and a lotion drainage pipe were the cactus. 照明3か所、化粧台排水管がカクカクだった点、浴室の壁の一部の色を改善しました。

Old version

Content ID:1836243

Published : 4 years ago

Last updated : 4 years ago

たるーる's profile Go to profile

blender2.9で3Dモデル素材を作成しています。皆様のお役に立つものを作っていきたいです。