2019/02/22
The section of the note of the explanation sentence that route when I used it was updated.
2019/08/27
I made a final adjustment and became free of charge.
Thank you for those who purchased it when it was a CP article.
2019/02/22
利用の際分かり難かった説明文の注意事項の欄を更新しました。
2019/08/27
最終調整を行い、無償化しました。
CP品だった際に購入して下さった方々、ありがとうございました＞＜
It becomes a sister product of the brush pen style brushes, Kaze_Fude.
A brush that can also draw clean lines as opposed to Kaze_Fude.
If you draw in the color layer, you can put out the Usuzumi in black and white. (Color setting for the layer required)
It is easy to grazed when I tilt it big or have it at an angle close to the opposite.
If you can write a brush size, the maximum value will change when you draw it strongly.
If you want to be extremely expressive, make brush size large, and if you want to draw an average line, take it small.
Too much brush size greatly delays the environment.
Adjust the size of your use to your environment.
(More than 300 dpi, brush size 15 ~ 100pix is recommended)
Notes
When writing in black and white, the first layer of black and white will not reflect the grazed.
The avoidance method is as follows.
I draw anything at once to the target layer.
Then "leave the contents without erasing" and change the layer property to monochrome layer.
After the contents are erased with an eraser etc., there is no problem.
Also, if you apply "color in preview" after the change, the effect of the Caspar will not be reflected in the line thereafter.
The application of the expression color, please the illustration, or after drawing up the line drawing.
Tsuki_Fude is the brush in contrast to Kaze_Fude I made before.
It makes you possible to draw a clean line.
It makes you possible to draw a clean line.
If you want to draw a clean line. Set layer mode to "Color layer".
Tsuki_Fude provide a beatiful gradient effect to drawing line in this layer mode.
Tsuki_Fude provide a beatiful gradient effect to drawing line in this layer mode.
When you change layer mode to "monochromatic". Then you can get scratch effect instead of gradient effect.
Scratch effect mainly controlled by drawing speed and tilt.
Scratch effect mainly controlled by drawing speed and tilt.
Try to use it carefully.
The larger brush size, the more latency.
Recommend brush size is
Less than 100 pixel, canvas resolution is
300 dpi or above.
Notice
------------------------------------------------------------
Scratch effect doesn't work when you use brush on "Monochromatic layer" from first.
You need to draw to "Color layer", and switch to "Monochromatic layer" to avoid the issue.
------------------------------------------------------------
------------------------------------------------------------
Scratch effect doesn't work when you use brush on "Monochromatic layer" from first.
You need to draw to "Color layer", and switch to "Monochromatic layer" to avoid the issue.
------------------------------------------------------------
Thank you for downloading Tsuki_Fude!
I Hope this brush helps you.
Have fun!
I Hope this brush helps you.
Have fun!
筆ペン風ブラシ、Kaze_Fudeの姉妹品になります。
Kaze_Fudeと対照的にクリーンな線も描くことができるブラシです。
カラーレイヤーで描いた場合は薄墨のような表現が、モノクロで描いた場合はカスレを出すことが出来ます。(要レイヤーの表現色設定)
大きく傾けたり、逆に垂直に近い角度で持つと掠れが出やすいです。
ブラシサイズを書けると強く描いた際の最大値が変わります。
極端な表現をされたい場合はブラシサイズを大きく、平均した線を描きたい場合は小さく取ってください。
ブラシサイズを大きく取りすぎると環境により大きく遅延が出ます。
利用するサイズを環境に合わせて調整してください。
(解像度は300dpi以上、ブラシサイズは15～100pixがおすすめです)
※注意事項
モノクロで書く際、最初にレイヤーをモノクロにすると掠れが反映されません。
回避方法は以下の通りです。
対象レイヤーに一度、何でもいいので描きます。
その後"描いた内容は消さずに残したまま"レイヤープロパティにてモノクロレイヤーに変更してください。
以降は内容を消しゴム等で消せば問題ありません。
また、変更した後に"プレビュー中の表現色"を適用すると、それ以降はカスレの効果が線に反映されません。
表現色の適用はイラスト、または線画を描き上げた後にお願いします。
Tsuki_Fude is the brush in contrast to Kaze_Fude I made before.
It makes you possible to draw a clean line.
It makes you possible to draw a clean line.
If you want to draw clean line. Set layer mode to "Color layer".
Tsuki_Fude provide a beatiful gradient effect to drawing line in this layer mode.
Tsuki_Fude provide a beatiful gradient effect to drawing line in this layer mode.
When you change layer mode to "monochromatic". then you can get scratch effect instead of gradient effect.
Scratch effect mainly controlled by drawing speed and tilt.
Scratch effect mainly controlled by drawing speed and tilt.
Try to use it carefully.
the larger brush size,the more latency.
recommend brush size is
less than 100 pixel,canvas resolution is
300dpi or above.
Notice
------------------------------------------------------------
Scratch effect does not work when you use brush on "Monochromatic layer" from first.
You need to draw to "Color layer"once,and switch to "Monochromatic layer"to avoid the issue.
------------------------------------------------------------
------------------------------------------------------------
Scratch effect does not work when you use brush on "Monochromatic layer" from first.
You need to draw to "Color layer"once,and switch to "Monochromatic layer"to avoid the issue.
------------------------------------------------------------
Thank you for downloading Tsuki_Fude!
I hope this brush helps you.
Have fun!
I hope this brush helps you.
Have fun!
Old version
Other materials by たなかもげたろう
Popular “Brush” materials
New materials
Badges
-
MVP ◆This user has contributed greatly to the management of the community, by posting many great responses to the questions asked. Once every three months, MVPs are determined based on the points earned during that period and will be recognized accordingly. -
New Valuable Player (NVP) ◆These are the next-best contributors to the community after MVPs. This is awarded to users who have not yet won an MVP award, based on the number of points they have earned. -
Official Expert ◆Chosen out of all MVP awardees, who are already proof of excellence, this is a testimony of outstanding correspondence in the community. After careful screening, they are appointed by CELSYS and assume their position.Note: Formally called “Evangelists” -
Official Moderator of CELSYS ◆Moderators are official CELSYS staff members who are fluent in Japanese as well as various other languages. Moderators are not experts on the software or illustration, so they are not able to directly answer your questions. However, moderators provide communication and language support to ensure that everyone can smoothly communicate with each other. -
CELSYS official accountThe Official Administrator Account